BUREEN is an insulator for speakers created from a completely new material that isolates vibration.
A graph of vibration transmission coefficient for a 30 kg speaker supported at three points is shown in the figure above. It can be seen that the vibration in the audible range is almost completely isolated and not transmitted.
It can be seen that almost no vibration from the speakers is transmitted to the installation site, e.g. desk, floor, floor, stand, etc.
W300mm - W350mm - H200mm 20g（1piece）
We are also particular about the shape. The conical shape of the load-bearing part ensures that the stress is always concentrated in the center.
We use a specially formulated polyurethane gel material for our speaker insulators. It is designed to be very viscoelastic, so it has completely different properties from rubber or other materials.
ABOUT LOAD CAPACITY
Special materials and a well-thought-out shape make BUREEN a speaker insulator that produces a crisp sound.
REGARDING THE PROPER LOAD
MIN 4.9kg (1piece) BEST 10.4kg (1piece) MAX 39.1kg (1piece)
The load per BUREEN should not exceed 40 kg. When supporting a speaker weighing more than 120 kg, increase the number of BUREENs.
up and down
We recommend using it in an orientation where the logo is upright, however, as the sound changes by changing the orientation, feel free to use it in whichever way you prefer.
The load applied per BUREEN should not exceed 40 kg. Although 3-point support is the standard, if being used on a heavier speaker, please use more BUREENs. Please be sure to place the BUREENs in a position such that the weight is evenly distributed and the speaker is in a stable position. For 3-point support, the recommended layout is to place two on the heavier side of the speaker.
If it gets dirty, it can be washed. Simply scrub the surface lightly with neutral detergent to clean. Please note that the logo print may come off if you rub the logo area strongly.